DigiDoor

Factory reset If the installation setup has to be repeated for any reason, a factory reset can be performed to return the operator to its original factory default state. This procedure also erases the master wireless wall console learned during step 5, but not the ekey remotes that have been recorded.
  • Remove power (including battery power if fitted.) (The Batteries may be disconnected by unplugging the 2-way connector on the battery charger board.)
  • Hold the “Enter” button while re-applying the power. The operator will travel to the closed direction for a period and stop.
  • All limit settings and the master wall console are erased.
  • Remove all power again and re-start the setup procedure.
      • Setting the limits The digidoor III ac/dc is fitted with a power cord and a 15Amp moulded plug. Plug this into a suitably positioned power socket, and:
      • Close the door manually then ensure that the manual lever is in the engaged position (Latch Lever horizontal), and move the door by hand until it engages with the operator.
      • Switch the power on. The controller will beep and the indicator will flash amber. (The indicator flashes amber during set-up mode.)
      • The obstacle limit is set to maximum by the factory and can be left in this position for initial setup unless a very lightweight door is used, in which case a lower force may be used during installation.
      • Press the Enter button (For a lightweight door press Enter Twice). The door will close slowly until the floor is reached. (Note: This process can be stopped, if necessary, by pressing the Enter button again, and a further press will continue or restart it.) The door will then open slowly until the open position is reached. The controller will beep and the door will close and open at normal speed. The controller will beep twice to indicate that the limits have been established.
      • To learn the first wall console (master), press the Enter button. The controller will beep and the indicator will flash amber rapidly.
      • Press the Operate button on the Wall Console. The controller will beep.
      • To confirm, press the Operate button on the Wall Console again. The controller will beep four times to show that set-up is complete, and the indicator will show green (Ready).
      • Adjust the Obstacle Sensing by means of the trimmer shown in Fig.17, while physically checking the force of the door on the shoulder. Also check that the door is able to sense a block 40mm high placed on the floor in the centre of the door. Note: This test should be repeated once a year.
      • If batteries are fitted as standard, connect these to the control board by plugging in the two-way connector as shown in Fig. 6 on Page 18.
      • To complete the installation check that the door operates reliably and inform the client/user of the safety features and the manual override procedure.
      Digidoor II/III Erase All Remotes
      • With the wall console make sure the light is off by using the light button on the wall console
      • Press and hold the light toggle button for about 10 seconds
      • At around 5 seconds the light will come on and go off at about 5 seconds
      • After another 5 seconds the light will flash to indicate that all the remotes have been erased
      Digidoor II/III Erase All Remotes
      • With the wall console make sure the light is off by using the light button on the wall console
      • Press and hold the light button for about 5 seconds
      • The light will go on and off – release the light toggle button on the wall console
      • Press the desired button on the remote (You have about 30 seconds to do this)
      • Press the same button again to confirm it
      • The light will flash repeatedly to indicate that the remote was added to the receiver